MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Remove the 2 screws.
![]() |
Detach the 4 clips.
Detach the claw to remove the upper steering column cover.
| 4. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Detach the 2 claws to remove the lower steering column cover.
| 5. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Disengage the 3 claws.
Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.
| 6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the 2 bolts.
Detach the 9 clips and claw.
![]() |
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY |
![]() |
Remove the 4 bolts and remove the instrument panel airbag.
Detach the 2 claws and disconnect the DLC3.
Disconnect the connector.
| 8. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY |
![]() |
Remove the bolt and air duct.
| 9. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU |
![]() |
Disconnect the 2 ECU connectors.
Remove the 2 screws and ECU.