Home › Power Source / Network ยท NETWORKING › CAN COMMUNICATION SYSTEM

DTC    B2624    Vehicles Speed Malfunction

for Preparation Click here


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the communication bus on a regular schedule. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the communication bus to prevent improper operation of the auto away/return function during driving.

DTC Code
Detection Condition
Trouble Area
B2624
  1. The auto away function is disabled with the last vehicle speed signal* at 10 km/h (6 mph) or more.
  2. Vehicle speed signal is lost for 10 seconds or more and the auto away/return function is disabled.
  1. CAN communication system
  2. Meter/gauge system
  3. Multiplex tilt and telescopic ECU

HINT:
*: If the ignition switch is turned off immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).


INSPECTION PROCEDURE

1.CHECK OTHER DTC OUTPUT
  1. Check if DTC B2621 is output (Click here).
    Result 
    Result
    Proceed to
    B2621 is not output
    A
    B2621 is output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT CODE (Click here)
A


2.READ VALUE USING TECHSTREAM (SPEED SIGNAL)
  1. Use the Data List to check if the speed signal is functioning properly.

    Tilt and Telescopic 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Freeze Speed Info
    Vehicle speed data/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
    Stop → Drive → Stop
    0 km/h (0 mph) → Same speed as indicated on speedometer → 0 km/h (0 mph)

Result 
Result
Proceed to
Tester indication is normal
A
Tester indication is abnormal
B

HINT:
A vehicle speed of 3 km/h (2 mph) or more may be displayed on the Techstream screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal input via the communication bus and is not a malfunction.



B
GO TO METER/GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)