NAVIGATION SYSTEM (for DVD) > Radio Broadcast cannot be Received or Poor Reception |

| 1.CHECK NAVIGATION RECEIVER ASSEMBLY |
Check the radio automatic station search function.
Check the radio automatic station search function by activating it.
|
| ||||
| OK | ||
| ||
| 2.CHECK OPTIONAL COMPONENTS |
Check for optional components (sunshade film, telephone antenna, etc.).
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
|
| ||||
| OK | ||
| ||
| 3.CHECK NAVIGATION RECEIVER ASSEMBLY |
![]() |
Remove the antenna plug from the navigation receiver assembly.
Turn the ignition switch to ACC with the navigation receiver assembly connector connected.
Turn the radio on and select AM mode.
Place a screwdriver, thin wire or other metal object on the navigation receiver antenna jack and check that noise can be heard from the speakers.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - AMPLIFIER ANTENNA) |
![]() |
Disconnect the I20 navigation receiver assembly connector.
Disconnect the I23 amplifier antenna assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I20-13 (ANT) - I23-1 (B) | Always | Below 1 Ω |
| I20-13 (ANT) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the I23 navigation receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I23-1 (B) - Body ground | Ignition switch ON Radio switch on | 11 to 14 V |
|
| ||||
| OK | |
| 6.CHECK ANTENNA CORD |
Remove the antenna plug of the navigation receiver and antenna.
Measure the resistance between the antenna and navigation receiver to check for an open circuit in the antenna cord.
Measure the resistance between the antenna cord and body ground to check for a short circuit in the antenna cord.
|
| ||||
| OK | |
| 7.REPLACE AMPLIFIER ANTENNA ASSEMBLY |
Replace the amplifier antenna assembly and check if radio broadcasts can be received normally.
|
| ||||
| OK | ||
| ||