Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Radio Broadcast cannot be Received or Poor Reception

for Preparation Click here


WIRING DIAGRAM


E232252E01


INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER ASSEMBLY
  1. Check the radio automatic station search function.

    1. Check the radio automatic station search function by activating it.

      OK:
      The radio automatic station search function works properly.



NG
Go to step 2
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

2.CHECK OPTIONAL COMPONENTS
  1. Check for optional components (sun-shade film, telephone antenna, etc.).

    1. Check if any optional components, that may decrease reception capacity, such as a sunshade film or telephone antenna, are installed.

      OK:
      Optional components are installed.

      NOTICE:
      Do not remove any optional components installed by the customer without his or her consent.



NG
Go to step 3
OK

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE) 

3.CHECK NAVIGATION RECEIVER ASSEMBLY


    E108381
  1. Remove the antenna plug from the navigation receiver assembly.

  1. Turn the ignition switch to ACC with the navigation receiver assembly connector connected.

  1. Turn the radio on and select AM mode.

  1. Place a screwdriver, thin wire or other metal object on the navigation receiver antenna jack and check that noise can be heard from the speakers.

    OK:
    Noise occurs.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - AMPLIFIER ANTENNA ASSEMBLY)
  1. Disconnect the I26 navigation receiver assembly connector.

  1. Disconnect the I23 amplifier antenna assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I26-8 (ANT) - I23-1 (B)
    Always
    Below 1 Ω
    I26-8 (ANT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK NAVIGATION RECEIVER ASSEMBLY


    E190367E03
  1. Disconnect the I23 amplifier antenna assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I23-1 (B) - Body ground
    Ignition switch ON
    Radio switch on
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Amplifier Antenna Assembly)



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


6.CHECK ANTENNA CORD SUB-ASSEMBLY
  1. Remove the antenna plug of the navigation receiver and antenna.

  1. Measure the resistance between the antenna and navigation receiver to check for an open circuit in the antenna cord.

    Standard Resistance:
    Below 1 Ω

  1. Measure the resistance between the antenna cord and body ground to check for a short circuit in the antenna cord.

    Standard Resistance:
    10 kΩ or higher



NG
REPLACE ANTENNA CORD ASSEMBLY
OK


7.REPLACE AMPLIFIER ANTENNA ASSEMBLY
  1. Replace the amplifier antenna assembly and check if radio broadcasts can be received normally.

    OK:
    Radio broadcasts can be received.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

NORMAL OPERATION