DTC B2603 Tilt and Telescopic Manual Switch Circuit Malfunction |
| DTC Code | Detection Condition | Trouble Area |
| B2603 | When operating the tilt and telescopic manual switch, an abnormal voltage value is input to the multiplex tilt and telescopic ECU. |
|

| 1.READ VALUE USING TECHSTREAM (TILT AND TELESCOPIC MANUAL SWITCH) |
![]() |
Use the Data List to check if the tilt and telescopic manual switch is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| T&T Manual SW Data | Voltage data of manual switch / min.: 0.00 V, max.: 4.99 V | Neutral position: Below 0.2 V Tilt up: 1.67 to 2.13 V Tilt down: 0.54 to 0.74 V Telescopic contract: 1.08 to 1.40 V Telescopic extend: 2.22 to 2.77 V | - |
| Result | Proceed to |
| Switch voltages in all directions are outside the standard. | A |
| Switch voltages in certain directions are outside the standard. | B |
| Switch voltages in all directions are within the standard. | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - HEADLIGHT DIMMER SWITCH) |

Disconnect the H57 multiplex tilt and telescopic ECU connector.
Disconnect the H11 headlight dimmer switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H57-4 (VC) - H11-8 (VC) | Always | Below 1 Ω |
| H57-3 (MSW) - H11-10 (MSW) | Always | Below 1 Ω |
| H11-8 (VC) - Body ground | Always | 10 kΩ or higher |
| H11-10 (MSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT MULTIPLEX TILT AND TELESCOPIC ECU (VC TERMINAL VOLTAGE) |
![]() |
Reconnect the H57 multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H57-4 (VC) - H57-3 (MSW) | Ignition switch ON | 4.9 to 5.1 V |
|
| ||||
| OK | |
| 4.INSPECT HEADLIGHT DIMMER SWITCH (TILT AND TELESCOPIC MANUAL SWITCH) |
![]() |
Disconnect the H11 headlight dimmer switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (VC) - 10 (MSW) | Tilt up | 360 Ω |
| Tilt down | 1990 Ω | |
| Telescopic contract | 790 Ω | |
| Telescopic extend | 160 Ω |
|
| ||||
| OK | ||
| ||