Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CHECK DTC OF NAVIGATION SYSTEM
      1. Refer to DTC Check/Clear procedures of the navigation system (for DVD) (Click here).

      2. Refer to DTC Check/Clear procedures of the navigation system (for SD) (Click here).
        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      GO TO NAVIGATION SYSTEM
      A


      4.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      Go to step 6
      A


      5.SYMPTOM SIMULATION

        NEXT


        6.CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM
        1. Refer to Navigation System (for DVD) (Click here).

        2. Refer to Navigation System (for SD) (Click here).
          Result 
          Result
          Proceed to
          Symptom does not appear
          A
          Symptom appears
          B



        B.
        FOLLOW THE NAVIGATION SYMPTOM CHART TO PERFORM TROUBLESHOOTING
        A


        7.PROBLEM SYMPTOMS TABLE
        1. Refer to Problem Symptoms Table (Click here).
          Result 
          Result
          Proceed to
          Fault is not listed in Problem Symptoms Table
          A
          Fault is listed in Problem Symptoms Table
          B



        B.
        Go to step 9
        A


        8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW
        1. Terminals of ECU (Click here).


        NEXT


        9.ADJUST, REPAIR OR REPLACE

          NEXT


          10.CONFIRMATION TEST

            NEXT

            END