DTC B1562 XM Tuner Disconnected (Burst Mode) |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1562 | When the master unit deletes the satellite radio tuner from the system components device list due to an AVC-LAN plus communication error. |
|

| 1.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC and check if the same trouble occurs again.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO COMPONENT TUNER) |
![]() |
Disconnect the I37 navigation receiver assembly connector.
Disconnect the I39 stereo component tuner assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I37-2 (TXO+) - I39-3 (TXI+) | Always | Below 1 Ω |
| I37-3 (TXI+) - I39-2 (TXO+) | Always | Below 1 Ω |
| I37-5 (TXO-) - I39-6 (TXI-) | Always | Below 1 Ω |
| I37-6 (TXI-) - I39-5 (TXO-) | Always | Below 1 Ω |
| I37-2 (TXO+) - Body ground | Always | 10 kΩ or higher |
| I37-3 (TXI+) - Body ground | Always | 10 kΩ or higher |
| I37-5 (TXO-) - Body ground | Always | 10 kΩ or higher |
| I37-6 (TXI-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT STEREO COMPONENT TUNER ASSEMBLY |
![]() |
Disconnect the I39 stereo component tuner assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I39-2 (TXO+) - I39-3 (TXI+) | Always | Below 1 Ω |
| I39-5 (TXO-) - I39-6 (TXI-) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||