DTC B1593 No Response from Stereo Component Amplifier |
DTC B15D3 Stereo Component Amplifier Disconnected |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1593 | Within the time-out period, there is no response from the stereo component amplifier to the following requests from the master unit:
|
|
| B15D3*1 | When either condition below is met:
|

| 1.CHECK OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING) |
Check for optional components.
Check that optional components (including associated wiring) which generate radio waves are not installed.
| Result | Proceed to |
| Optional components (including associated wiring) are installed. | A |
| Optional components (including associated wiring) are not installed. | B |
|
| ||||
| A | |
| 2.REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING) |
Remove optional components (including associated wiring).
| NEXT | |
| 3.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs and check if the same trouble occurs again.
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the I16 and I17 stereo component amplifier connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I16-2 (GND) - Body ground | Always | Below 1 Ω |
| I16-6 (GND2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I16-1 (+B) - I16-2 (GND) | Always | 11 to 14 V |
| I16-3 (+B2) - I16-2 (GND) | Always | 11 to 14 V |
| I17-12 (ACC) - I16-2 (GND) | Ignition switch ACC | 11 to 14 V |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the I20 navigation receiver assembly connector.
Disconnect the I17 stereo component amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I20-5 (ATX+) - I17-8 (TX+) | Always | Below 1 Ω |
| I20-15 (ATX-) - I17-7 (TX-) | Always | Below 1 Ω |
| I20-5 (ATX+) - Body ground | Always | 10 kΩ or higher |
| I20-15 (ATX-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.REPLACE STEREO COMPONENT AMPLIFIER |
Replace the stereo component amplifier (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check if the same trouble occurs again.
|
| ||||
| OK | ||
| ||