Home › General › MAINTENANCE › BODY

BODY > GENERAL MAINTENANCE



1. INSPECT TIRE AND INFLATION PRESSURE (Except North America)
  1. Check the tires for wear and proper inflation pressure (Click here).



2. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
  1. Where necessary, tighten all the parts of the chassis.

    1. Front axle and suspension
    2. Drivetrain
    3. Rear axle and suspension
    4. Brake system
    5. Engine mounting, etc.

  1. Where necessary, tighten all the parts of the body.

    1. Seat belt system
    2. Seat
    3. Doors and hood
    4. Body mountings
    5. Fuel tank
    6. Exhaust pipe system, etc.



3. INSPECT LIGHTS, HORN, WIPERS AND WASHERS (Except North America)


4. REMOVE REFRIGERANT AMOUNT FOR AIR CONDITIONER (Except North America)
  1. Check the refrigerant pressure (Click here).



5. REPLACE AIR CONDITIONING FILTER
  1. Remove the lower instrument panel finish panel sub-assembly RH (Click here).

  1. Remove the air filter cover plate.

  1. Remove the air refiner element.

  1. Replace the filter with a new one.

  1. Install the air refiner element.

  1. Install the air filter cover plate.

  1. Install the lower instrument panel finish panel sub-assembly RH (Click here).



6. FINAL INSPECTION
  1. Check the operation of the body parts.

    1. Hood

      1. Auxiliary catch operates properly.
      2. Hood locks securely when closed.

    2. Front and rear doors

      1. Door locks operate properly.
      2. Doors close properly.

    3. Back door

      1. Door lock operates properly.

    4. Seats

      1. Seat adjusts easily and locks securely in any position.
      2. Front seatback locks securely in any position.
      1. Folding-down rear seatbacks lock securely.

    5. Be sure to deliver a clean vehicle. Especially check:

      1. Steering wheel
      2. Shift lever knob
      3. All switch knobs
      1. Door handles
      1. Seats