Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRE
  1. Check the tires for wear and proper inflation pressure.

    Standard Cold Tire Inflation Pressure:
    Tire Size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    P275/65R18
    230 (2.3, 33)
    230 (2.3, 33)
    P275/55R20
    210 (2.1, 30)
    230 (2.3, 33)



    R003031
  1. Using a dial indicator, check the tire runout.

    Tire runout:
    3.0 mm (0.118 in.) or less



2. ROTATE TIRE


C140312E02

HINT:
Rotate the tires as shown in the illustration.



3. INSPECT WHEEL BALANCE


    C080976E04
  1. Check and adjust the off-the-car balance.

  1. If necessary, check and adjust the on-the-car balance.

    Standard imbalance after adjustment:
    8 g (0.0180 lb) or less

    NOTICE:

    1. C147100E02
      Using a cleaning detergent, remove dirt, oil and water from the areas shown in the illustration (approximately 25 mm (0.993 in.)).
    2. Do not touch the adhesive part of the balance weight.
    3. Adhere the balance weight to the areas shown in the illustration.
    4. Push the balance weight securely with your fingers to attach it.
    5. Do not reuse the balance weight.



4. INSPECT FRONT AXLE HUB
(Click here)


5. INSPECT REAR AXLE HUB
(Click here)