Home › General › MAINTENANCE › BRAKE

BRAKE > GENERAL MAINTENANCE



1. INSPECT BRAKE PEDAL AND PARKING BRAKE (Except North America)
  1. Inspect the brake pedal and parking brake.
    Type
    See procedures
    Brake pedal
    Click here
    Parking brake
    Click here



2. INSPECT BRAKE LINE PIPES AND HOSES

HINT:
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.



    P009958E01
  1. Using a mirror, check the entire circumference and length of the brake lines and hoses for:

    1. Damage
    2. Wear
    3. Deformation
    4. Cracks
    5. Corrosion
    6. Leaks
    7. Bends
    8. Twists

  1. Check all the clamps for tightness and the connections for leakage.

  1. Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.

  1. Check that the lines are installed properly and pass through the center of the grommets.



3. INSPECT BRAKE LININGS AND DRUMS, PADS AND DISCS
  1. Check the brake linings and drums of the parking brake (Click here).

  1. Check the brake pads and discs.
    Type
    See procedures
    Front
    Click here
    Rear
    Click here

    HINT:

    1. S002432
    2. If a squealing or scraping noise is heard from the brake while driving, check the pad wear indicator.
    3. If there are traces of the indicator contacting the disc rotor, the disc pad should be replaced.



4. INSPECT BRAKE FLUID
  1. Inspect the brake fluid (Click here).



5. REPLACE BRAKE FLUID
  1. Replace the brake fluid (Click here).