Home › Suspension › REAR SUSPENSION › REAR PNEUMATIC CYLINDER

REAR PNEUMATIC CYLINDER > INSTALLATION

for Preparation Click here



1. INSTALL REAR PNEUMATIC CYLINDER ASSEMBLY LH


    C180798E01
  1. Install the pneumatic cylinder as shown in the illustration.

    HINT:
    Rotate the pneumatic cylinder to fasten the pneumatic cylinder into the spring seat on the frame.

  1. Connect the height control tube (Click here).



    C180769
  1. Install a new clip.



    C181283E01
  1. Lower the lift that is supporting the frame to allow the tire to touch the floor and check that the piston-side pneumatic cylinder pin is in the center hole of the No. 2 lower arm.

  1. Start the engine to fill the pneumatic cylinder with air.



    C180770
  1. Install the bolt.

    Torque:
    17 N*m{ 173 kgf*cm , 13 ft.*lbf }