Home › Engine / Hybrid System · CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    C1267    Brake Pedal Load Sensing Switch

for Preparation Click here


DESCRIPTION

The skid control ECU receive signals from the active brake booster's internal micro switch to detect if the brake pedal is depressed.

DTC No.
DTC Detection Condition
Trouble Area
C1267
During cruise control operation a micro switch error is stored under the following conditions: A micro switch error flag remains ON for 0.5 seconds or more, the micro switch condition does not match the signal sent from the VSC system, or the micro switch and oil pressure sensor values do not match for 1 second or more.
  1. Active brake booster (micro switch)
  2. ECM
  3. VSC system
  4. Wire harness or connector

WIRING DIAGRAM


E163997E02


INSPECTION PROCEDURE

HINT:
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

1.CHECK DTC (FOR VEHICLE STABILITY CONTROL SYSTEM)
  1. Check the DTC for Vehicle Stability Control System (Click here).
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO DTC CHART (Click here)
A


2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - ECM)
E227785E01
  1. Disconnect the A27 connector from the ECM.

  1. Disconnect the A19 connector from the ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-40 (PSOO) - A27-36 (STV)
    Always
    Below 1 Ω
    A19-40 (PSOO) or A27-36 (STV) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECM and ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE VSC ACTUATOR ASSEMBLY
  1. Temporarily replace the VSC actuator assembly with a new or normally functioning one (Click here).


NEXT


4.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


5.CHECK FOR DTC
  1. Check for DTC (Click here).

    OK:
    C1267 is not output.

Result 
Result
Proceed to
OK
A
NG (for 1UR-FE)
B
NG (for 3UR-FE)
C
NG (for 3UR-FBE)
D


B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A

END (VSC ACTUATOR ASSEMBLY IS DEFECTIVE)