THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit |

| 1.READ VALUE USING TECHSTREAM |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream main switch on.
Select the item below in the Data List and read the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Hood Courtesy Switch | Engine hood courtesy switch signal ON/OFF | ON: Engine hood is OPEN OFF: Engine hood is CLOSED | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT ENGINE HOOD COURTESY SWITCH |
Disconnect the A35 engine hood courtesy switch connector.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | LOCK position | Below 1 Ω |
| UNLOCK position | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE HOOD COURTESY SWITCH) |
![]() |
Disconnect the H4 main body ECU connector.
Disconnect the A35 engine hood courtesy switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H4-16 (HCTY) - A35-1 | Always | Below 1 Ω |
| A35-2 - Body ground | Always | Below 1 Ω |
| H4-16 (HCTY) or A35-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||