Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. REMOVE PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



4. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



5. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



6. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Disengage the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B229064
  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



8. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY


    B225997
  1. Remove the 4 bolts and remove the instrument panel airbag.

  1. Detach the 2 claws and disconnect the DLC3.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



9. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


    C154523
  1. Remove the bolt and defroster nozzle duct.



10. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin from the brake pedal lever.



11. REMOVE STOP LIGHT SWITCH ASSEMBLY
  1. Disconnect the connector.



    E161861
  1. Turn the stop light switch counterclockwise and remove it.



12. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
  1. Remove the stop light switch mounting adjuster.



13. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY


    C208544E01
  1. Remove the brake pedal return spring.

  1. Remove the bolt from the No. 3 brake pedal bracket.



    C208543
  1. Remove the bolt, nut and No. 3 brake pedal bracket from the brake pedal support.



    C154462
  1. Remove the 4 nuts and brake pedal support.



14. REMOVE BRAKE PEDAL PAD
  1. Remove the brake pedal pad.