REAR POWER SEAT CONTROL SYSTEM > Back Door Courtesy Switch Circuit |

| 1.READ VALUE USING TECHSTREAM (BACK DOOR COURTESY SWITCH) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Body Electrical / Back Door P/W / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Back Door Courtesy Switch | Back Door Courtesy Switch / ON or OFF | ON: Back door opened OFF: Back door closed | - |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (BACK DOOR ECU - FOLD SEAT CONTROL ECU) |
![]() |
Disconnect the V2 ECU connector.
Disconnect the O34 or P20 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| V2-17 (OCTY) - O34-5 (BDCY) | Always | Below 1 Ω |
| V2-17 (OCTY) or O34-5 (BDCY) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| V2-17 (OCTY) - P20-5 (BDCY) | Always | Below 1 Ω |
| V2-17 (OCTY) or P20-5 (BDCY) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE BACK DOOR ECU |
Temporarily replace the back door ECU with a new or normally functioning one (Click here).
| NEXT | |
| 4.CHECK POWER SEAT CONTROL SYSTEM (OPERATION) |
Check the power folding function (Click here).
|
| ||||
| OK | ||
| ||