Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely small sound can be heard.

WIRING DIAGRAM


E190161E02


INSPECTION PROCEDURE

1.CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY


    E153729E07
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I17-1 (MUTE) - Body ground
    Ignition switch ACC, Audio system playing → Changing source
    Above 3.5 V → Below 1 V



NG
Go to step 2
OK

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO COMPONENT AMPLIFIER)


    E191667E02
  1. Disconnect the I20 navigation receiver assembly connector.

  1. Disconnect the I17 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I20-7 (MUTE) - I17-1 (MUTE)
    Always
    Below 1 Ω
    I20-7 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)