Home › Engine / Hybrid System ยท 1UR-FE › STARTING › STARTER (for 1.6 kW Type)

STARTER (for 1.6 kW Type) > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY


    A215546
  1. Install the flywheel housing side cover.



    A215548
  1. Install the starter with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



    A215550
  1. Connect the starter wire with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Connect the starter connector.

  1. Connect the 2 wire harness clamps.



2. INSTALL STARTER COVER


    A215551
  1. Install the starter cover with the 3 bolts.

    Torque:
    12 N*m{ 117 kgf*cm , 8 ft.*lbf }



3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
  1. Install the exhaust manifold RH (Click here).



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).