Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > VSC OFF Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via the CAN communication system.
When the vehicle is changed to 4WD (L4 mode) and the center differential locks, VSC control turns off and the VSC OFF indicator light illuminates.

WIRING DIAGRAM


C244863E02


INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

HINT:
If the center differential cannot change from FREE to LOCK or LOCK to FREE, inspect and repair the touch select 2-4 and high-low system first.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (VSC OFF INDICATOR LIGHT)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream ON.

  1. Select the Active Test mode and operate the VSC OFF indicator light using the Techstream.

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    VSC OFF Indicator Light
    VSC OFF indicator light
    Indicator light ON/OFF
    Observe combination meter

  1. Check that the VSC OFF indicator light turns on and off in the combination meter when using the Techstream.

    OK:
    The VSC OFF indicator light turns ON and OFF in accordance with the Techstream operation.

    HINT:
    When the VSC OFF indicator light remains illuminated, there may be an open in the wire harness of the combination meter or abnormalities in the meter circuit.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


3.INSPECT VSC OFF SWITCH


    C179171E02
  1. Remove the VSC OFF switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 - 9
    Switch is pressed
    Below 1 Ω
    Switch is not pressed
    10 kΩ or higher



NG
REPLACE VSC OFF SWITCH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH)


    C240479E01
  1. Disconnect the A19 ECU connector.

  1. Disconnect the H29 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-4 (CSW) - H29-9
    Always
    Below 1 Ω
    A19-4 (CSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE VSC ACTUATOR ASSEMBLY (Click here)