Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1290/66    Steering Angle Sensor Zero Point Malfunction

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
C1290/66
Steering angle sensor zero point deviates from zero point stored in skid control ECU by 20 degrees or more.
  1. Steering angle sensor
  2. Steering angle sensor circuit
  3. CAN communication system
  4. VSC actuator (skid control ECU)

WIRING DIAGRAM

Refer to C1231/31 .

INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.DISCONNECT NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal to clear the steering angle sensor zero point.


NEXT


2.PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION
  1. Drive the vehicle straight ahead at 15 km/h (9 mph) or more for a few seconds (zero point is obtained automatically).


NEXT


3.RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Turn the ignition switch to ON.

  1. Check if the same DTC is recorded (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A


4.REPLACE STEERING ANGLE SENSOR
  1. Replace the steering angle sensor (Click here).


NEXT


5.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is recorded (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE VSC ACTUATOR ASSEMBLY (Click here)