FUEL SYSTEM > PRECAUTION |
| 1.DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Turn the lock lever and disconnect the connector of the fuel pump ECU.
| *1 | Lock Lever |
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.
Crank the engine again, then check that the engine does not start.
Loosen the fuel tank cap, then discharge the pressure in the fuel tank completely.
![]() |
Connect the connector of the fuel pump ECU.
Turn the lock lever and secure the connector with the lock lever.
| *1 | Lock Lever |
| 2.FUEL SYSTEM |
When disconnecting the high pressure fuel line, a large amount of gasoline will spill out. Follow these procedures.
Perform the "DISCHARGE FUEL SYSTEM PRESSURE" procedures above.
![]() |
Put a container under the connecting part of the pressure line.
Slowly loosen the connection.
Disconnect the connection.
Plug the connection with a rubber plug.
![]() |
Observe these precautions when removing and installing the injectors:
| *1 | O-Ring |
| *2 | Delivery Pipe |
| *a | CORRECT |
| *b | INCORRECT |
![]() |
Install the injector to the delivery pipe and intake manifold as shown in the illustration.
| *1 | Delivery Pipe |
| *2 | O-Ring |
| *3 | Injector |
| *4 | Insulator |
| *5 | Cylinder Head |
Observe these precautions when disconnecting the fuel tube connector (for Quick Type).
![]() |
for Fuel Hose Connector Cover Type:
Detach the lock claw by lifting up the cover, as shown in the illustration.
| *a | for Fuel Hose Connector Cover Type |
![]() | Pull |
![]() |
for Fuel Pipe Clamp Type:
Remove the fuel pipe clamp from the fuel tube connector.
| *a | for Fuel Pipe Clamp Type |
| *1 | Fuel Pipe Clamp |
Check for dirt or mud on the pipe and around the connector before disconnection. Clean if necessary.
![]() |
Pinch the connector and disconnect the connector and pipe.
![]() | Pinch |
![]() | Pull |
Check for dirt or mud on the seal surface of the disconnected pipe. Clean if necessary.
![]() |
To protect the disconnected pipe and connector from damage and contamination, cover it with a plastic bag.
| *1 | Plastic Bag |
![]() |
Observe these precautions when connecting the fuel tube connector (for Quick Type).
![]() | Push |
Check that there is no damage or contamination in the connected part of the pipe.
Align the axis of the connector with the axis of the pipe. Push the pipe into the connector until the connector makes a "click" sound. If the connection is tight, apply a small amount of fresh spindle oil or gasoline on the tip of the pipe.
![]() |
After having finished the connection, try to pull apart the pipe and the connector to confirm that they are securely connected.
![]() | Pull |
![]() |
for Fuel Pipe Clamp Type:
Install the fuel pipe clamp to the connector.
| *a | for Fuel Pipe Clamp Type |
| *1 | Fuel Pipe Clamp |
![]() |
for Fuel Hose Connector Cover Type:
Attach the lock claw to the connector by pushing down on the cover, as shown in the illustration.
| *a | for Fuel Hose Connector Cover Type |
![]() | Push |
Check that there is no fuel leakage.
| 3.CHECK FOR FUEL LEAK |
Check that there are no fuel leaks after performing maintenance anywhere on the fuel system .