Home › Engine / Hybrid System ยท 1UR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL REAR CRANKSHAFT OIL SEAL
  1. Apply MP grease to the lip of a new oil seal.



    A214560E01
  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-56010  

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap on the oil seal at an angle.



2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A163778E01
  1. Using SST, hold the crankshaft.

    SST
    09213-70011  
    09330-00021  



    A217514E01
  1. Install the crankshaft angle sensor rotor.

    HINT:
    Align the pin hole of the crankshaft angle sensor rotor with the pin of the crankshaft.



    A217515E01
  1. Install the drive plate and rear drive plate spacer onto the crankshaft.



    A057108E09
  1. Apply adhesive to 2 or 3 threads of the 8 bolts.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



    A214574E01
  1. Install and uniformly tighten 10 new bolts in the sequence shown in the illustration.

    Torque:
    30 N*m{ 301 kgf*cm , 22 ft.*lbf }

    NOTICE:
    1. Do not reuse the drive plate installation bolts.
    2. Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.



    A149106E01
  1. Mark the top of each drive plate installation bolt with paint.

  1. Tighten the drive plate installation bolts 90° as shown in the illustration.

  1. Check that the painted marks are now at a 90° angle to the top.



3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
  1. for 2WD:
    Refer to the following procedures (Click here).

  1. for 4WD:
    Refer to the following procedures (Click here).



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).