Home › Power Source / Network ยท 1UR-FE BATTERY / CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FAN AND GENERATOR V BELT
  1. Remove the fan and generator V belt (Click here).



4. REMOVE AIR CLEANER ASSEMBLY


    A215422
  1. Disconnect the MAF meter connector and clamp.

  1. Disconnect the ventilation hose and vacuum hose.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner.



5. REMOVE FRONT FENDER APRON SEAL RH
  1. Remove the 6 clips and fender apron seal.



6. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


C181326
  1. Disconnect the oil pressure sensor connector.



7. DISCONNECT SOLENOID VALVE CONNECTOR


C181333
  1. Disconnect the solenoid valve connector.



8. DISCONNECT VANE PUMP ASSEMBLY


C181328
  1. Remove the 2 bolts and vane pump assembly.



9. REMOVE GENERATOR ASSEMBLY


    A215539
  1. Remove the terminal cap.

  1. Disconnect the generator connector.

  1. Remove the nut and disconnect the generator wire.

  1. Remove the bolt and disconnect the wire harness bracket from the generator.



    A216790
  1. Remove the 3 bolts, nut and generator.