Home › Suspension › FRONT SUSPENSION › FRONT UPPER SUSPENSION ARM

FRONT UPPER SUSPENSION ARM > REMOVAL

for Preparation Click here



1. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING LH
(Click here)


2. DISCONNECT SKID CONTROL SENSOR WIRE


C155974E01
  1. Remove the 2 bolts and disconnect the sensor wire from the steering knuckle and suspension upper arm.



3. DISCONNECT STEERING KNUCKLE LH
  1. Support the front suspension lower arm LH with a jack.

  1. Remove the clip and the nut.



    C155977E01
  1. Using SST, disconnect the upper ball joint from the steering knuckle.

    SST
    09628-62011  



4. REMOVE FRONT FENDER APRON SEAL LH


C155975
  1. Using a clip remover, remove the 6 clips and apron seal.



5. REMOVE FRONT FENDER APRON SEAL REAR LH


C159163
  1. Using a clip remover, remove the 5 clips and apron seal.



6. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY


C155976
  1. Remove the nut, bolt, 2 washers and suspension upper arm.