Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the radio receiver assembly.
It also supplies power from the radio receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM


E177208E15


INSPECTION PROCEDURE

1.CHECK RADIO RECEIVER ASSEMBLY


    E190376E01
  1. Disconnect the I36 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I36-5 (MIC-) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I36-3 (MACC) - Body ground
    Ignition switch ACC
    4.75 to 5.25 V



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - ROOF CONSOLE BOX)


    E190371E01
  1. Disconnect the I36 radio receiver assembly connector.

  1. Disconnect the U7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I36-3 (MACC) - U7-10 (ACC)
    Always
    Below 1 Ω
    I36-2 (MIC+) - U7-9 (MIC+)
    Always
    Below 1 Ω
    I36-5 (MIC-) - U7-8 (MIC-)
    Always
    Below 1 Ω
    I36-1 (SNS2) - U7-14 (SGND)
    Always
    Below 1 Ω
    I36-3 (MACC) - Body ground
    Always
    10 kΩ or higher
    I36-2 (MIC+) - Body ground
    Always
    10 kΩ or higher
    I36-5 (MIC-) - Body ground
    Always
    10 kΩ or higher
    I36-1 (SNS2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK
  1. Replace the telephone microphone assembly with a normal one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE IS FAULTY)