Home › Engine / Hybrid System ยท 3UR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCHARGE FUEL SYSTEM PRESSURE

CAUTION:
  1. Do not disconnect any part of the fuel system until you have discharged the fuel system pressure.
  2. After discharging the fuel pressure, place a cloth or equivalent over fittings as you separate them to reduce the risk of fuel spray on yourself or in the engine compartment.

  1. Disconnect the cable from the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



    A240791E01
  1. Turn the lock lever and disconnect the connector of the fuel pump ECU.
    Text in Illustration 
    *1
    Lock Lever

  1. Connect the cable to the negative (-) battery terminal.

  1. Start the engine. After the engine has stopped on its own, turn the ignition switch off.

    HINT:
    DTC P0171/0174 (system too lean) may be set.

  1. Crank the engine again, and then check that the engine does not start.

  1. Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.



    A240793E01
  1. Connect the connector of the fuel pump ECU.

  1. Turn the lock lever and secure the connector with the lock lever.
    Text in Illustration 
    *1
    Lock Lever



3. REMOVE V-BANK COVER


A165576E03
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



4. REMOVE AIR CLEANER HOSE ASSEMBLY


A187008
  1. Disconnect the vacuum hose and ventilation hose.

  1. Loosen the 2 clamps.

  1. Remove the air cleaner hose.



5. REMOVE NO. 2 FUEL TUBE SUB-ASSEMBLY


    A161418
  1. Disconnect the No. 2 fuel tube from the fuel pressure regulator (for quick type) (Click here).



6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A161400
  1. Disconnect the vacuum sensing hose from the fuel pressure regulator.



    A161401
  1. Remove the 2 bolts, and pull out the fuel pressure regulator.

  1. Remove the O-ring from the pressure regulator.