DTC P0607 Control Module Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0607 | Either condition is met:
|
|
| Related DTCs | P0607: Control module performance |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | HO2 sensor |
| Frequency of operation | Continuous |
| Duration | 60 seconds |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever the following DTCs are not present | None |
| Engine | Running |
| Estimated HO2 sensor temperature | 450 to 800°C (842 to 1472°F) |
| HO2S transistors | Fail |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menu: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs (Click here).
| Result | Proceed to |
| DTC P0607 and P0136, P0137, P0138, P0156, P0157 or P0158 are output | A |
| Only DTC P0607 is output | B |
|
| ||||
| A | |
| 2.INSPECT DTC (P0136, P0137, P0138, P0156, P0157 OR P0158) |
Inspect the P0136, P0137, P0138, P0156, P0157 or P0158 flowchart.
|
| ||||
| 3.CHECK FOR EXHAUST GAS LEAK |
Allow the engine to idle and rev the engine.
Check for exhaust gas leaks around the heated oxygen sensor.
If any exhaust gas leaks are present, repair them and proceed to "Perform Confirmation Driving Pattern". If no exhaust gas leaks are present proceed to "Perform Confirmation Driving Pattern".
| NEXT | |
| 4.PERFORM CONFIRMATION DRIVING PATTERN |

Clear DTCs (Click here).
Connect the Techstream to the DLC3.
Start the engine.
Warm up the engine until the engine coolant temperature becomes 75°C (167°F) or more.
Perform the drive pattern.
Accelerate the vehicle to 80 km/h (50 mph) and stop the vehicle.
Drive the vehicle between 60 and 80 km/h (35 and 50 mph) for 5 minutes.
Enter the following menu: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0607 and P0136, P0137, P0138, P0156, P0157 or P0158 are output | A |
| Only DTC P0607 is output | B |
| DTC is not output | C |
|
| ||||
|
| ||||
| A | |
| 5.INSPECT DTC (P0136, P0137, P0138, P0156, P0157 OR P0158) |
Inspect the P0136, P0137, P0138, P0156, P0157 or P0158 flowchart.
| NEXT | |
| 6.INSPECT ECM |
Clear DTCs (Click here).
Stop the engine and wait for 30 minutes.
Connect the Techstream to the DLC3.
Start the engine and allow it to idle for 2 minutes.
Turn the Techstream on.
Enter the following menu: Powertrain / Engine and ECT / Trouble Codes.
Check the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0607 is output | B |
|
| ||||
| A | ||
| ||