Home › Engine / Hybrid System ยท 3UR-FBE › STARTING › STARTER

STARTER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



4. REMOVE FRONT FENDER APRON SEAL RH
  1. Remove the 6 clips and fender apron seal.



5. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
  1. Remove the dipstick.

  1. Disconnect the wire harness clamp.



    A164432
  1. Remove the bolt and dipstick guide.

  1. Remove the O-ring from the dipstick guide.



6. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector and 2 clamps.



    A184982
  1. Remove the 2 bolts from the center exhaust pipe.

  1. Remove the 3 nuts, front exhaust pipe and 2 gaskets.



7. REMOVE FRONT NO. 3 FLOOR HEAT INSULATOR


A184950
  1. Remove the 4 nuts and front No. 3 floor heat insulator.



8. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A162752
  1. Remove the 3 bolts and No. 1 exhaust manifold heat insulator.



9. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH


    A162754
  1. Remove the 10 nuts, exhaust manifold sub-assembly RH and 2 gaskets.



10. REMOVE STARTER COVER


    A162756
  1. Remove the 3 bolts and starter cover.



11. REMOVE STARTER ASSEMBLY


    A258301
  1. Detach the 2 wire harness clamps.

  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.



    A258302
  1. Remove the 2 bolts and starter.



    A162758
  1. Remove the flywheel housing side cover.