Home › Engine / Hybrid System ยท 1UR-FE › ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK SENSOR


A215437E01
  1. Install the 4 sensors with the 4 bolts so that the sensors are angled as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    NOTICE:
    The acceptable installation angle of the sensor is between 10° upward and downward from the horizontal position.

  1. Connect the 4 sensor connectors.



2. INSTALL SEPARATOR CASE


A215435
  1. Install the separator case with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



3. INSTALL INTAKE MANIFOLD
  1. Install the intake manifold (Click here).