Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



4. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



5. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure for both sides.



6. REMOVE FRONT PILLAR GARNISH LH

HINT:
Use the same procedure for both sides.



7. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Disengage the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B229064
  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



10. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B161741
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



11. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B161742
  1. Detach the 12 clips and remove the console panel.



12. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B222976
  1. Move the shift lever to N.

  1. Remove the clip.

  1. Detach the 6 clips and remove the console panel.

  1. Disconnect the connector



13. REMOVE REAR CONSOLE BOX POCKET


B188221
  1. Remove the rear console box pocket.



14. REMOVE CONSOLE BOX CARPET


B188222
  1. Remove the console box carpet.



15. REMOVE REAR CONSOLE BOX ASSEMBLY


B188223
  1. Disconnect the connectors.



    B192330
  1. Remove the 4 bolts and 2 screws.

  1. Detach the 6 claws and remove the rear console box.



16. REMOVE FRONT CONSOLE BOX


B222975
  1. Detach the 2 clamps.

  1. Remove the 2 clips.

  1. Remove the 5 screws and the front console box.



17. REMOVE AIRBAG SENSOR ASSEMBLY


B192367E01

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. Pull the lever down and detach the connector holder.



    B192369
  1. Remove the 3 bolts and remove the airbag sensor.