CRUISE CONTROL MAIN SWITCH > INSTALLATION |
| 1. INSTALL CRUISE CONTROL MAIN SWITCH |
![]() |
Install the switch, as shown in the illustration.
![]() |
Install the 2 screws.
Connect the connector.
| 2. INSTALL STEERING PAD |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Check that the horn sounds.
If the horn does not sound, inspect the horn system.
| 3. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 4. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).