Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Fold Down Seat Type)

FRONT SEAT ASSEMBLY (for Fold Down Seat Type) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT SEAT HEADREST ASSEMBLY


4. REMOVE SEAT TRACK COVER OUTER RH
  1. Operate the seat track adjusting handle to move the seat to the foremost position.



    B191067
  1. Disengage the 2 claws and remove the seat track cover.



5. REMOVE SEAT TRACK COVER INNER RH


    B200255
  1. Disengage the 2 claws and remove the seat track cover.



6. REMOVE FRONT SEAT ASSEMBLY RH


    B191041
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the rearmost position.



    B191042
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the center position.

  1. Disconnect the seat wire connectors under the seat.

  1. Remove the front seat.

    NOTICE:
    Be careful not to damage the vehicle body.