Home › Drivetrain ยท A760F AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY


    C179208E01
  1. Install the transmission floor shift with the 4 bolts. Tighten the bolts in the order shown in the illustration.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Connect the clamp and 2 connectors.



2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    C179207
  1. Install the cable outer of the transmission control cable to the shift lever retainer, and install a new clip.



    C179205E01
  1. Connect the transmission control cable end to the shift lever.

    NOTICE:
    Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable end's ridged side is facing upward.



3. INSTALL FRONT CONSOLE BOX ASSEMBLY
  1. Install the front console box (Click here).



4. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.

  1. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to S.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves rearward after moving the shift lever to R.
    If the operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.



5. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to N.



    C155901E02
  1. Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press out the lock piece from the back side to release the lock.



    C155902E02
  1. Check that the s spring of the adjust case is applying enough tension to the shift control cable. Then press in the lock piece to set the lock.

    NOTICE:
    1. Use your hand to push in the lock piece. Do not use any tools.
    2. Securely push in the lock piece so that the protrusion of the slider is above the lock piece.

  1. Return the cover of the adjust case to its original position.

  1. Inspect the shift lever operation after the adjustment.