DTC P060E Internal Control Module Throttle Position Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060E | When either condition below is met:
| ECM |
| Related DTCs | None |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | - |
| Frequency of operation | Once per driving cycle |
| Duration | 1 second |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present | None |
| DMA communication error | Not detected |
| When one of following conditions is met: | Condition 1 or 2 |
| 1. Difference of main TP and sub TP | 0.3 V or more |
| 2. Difference of main brake switch signal and sub brake switch signal | Different |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK FOR DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTCs (Click here).
Turn the Techstream off.
Turn the ignition switch off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check for DTCs.
|
| ||||
| OK | ||
| ||