TRANSMISSION CONTROL CABLE > INSTALLATION |
| 1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Insert the floor shift transmission control cable from the vehicle interior, and install the cable retainer with the 2 bolts.
![]() |
Install the cable outer of the transmission control cable to the shift lever retainer, and install a new clip.
![]() |
Connect the control cable end to the shift lever.
Move the shift lever to the N position.
![]() |
Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
![]() |
Connect the control cable with a new clip and the nut.
![]() |
Connect the transmission control cable support with the nut.
| 2. ADJUST SHIFT LEVER POSITION |
Move the shift lever to N.
![]() |
Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press out the lock piece from the back side to release the lock.
![]() |
Check that the s spring of the adjust case is applying enough tension to the shift control cable. Then press in the lock piece to set the lock.
Return the cover of the adjust case to its original position.
Inspect the shift lever operation after the adjustment.
| 3. INSPECT SHIFT LEVER POSITION |
When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.
Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to S.
Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves rearward after moving the shift lever to R.
If the operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.
| 4. INSTALL FRONT CONSOLE BOX |
Install the front console box (Click here).