Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE REAR DOOR FRAME GARNISH


    B190577
  1. Disengage the 6 clips and remove the rear door frame garnish.



4. REMOVE REAR DOOR ARMREST BASE UPPER PANEL


    B190574
  1. Disengage the 2 clips and 5 claws and remove the rear door armrest base upper panel.



5. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    B190575
  1. Using a moulding remover, disengage the 4 claws and remove the rear door inside handle bezel plug.



6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


B190578
  1. Remove the rear door armrest cover.

  1. Remove the 2 screws.



    B190579
  1. Disengage the 9 clips.

  1. Disconnect the connector.



    B190580
  1. Disconnect the rear door lock remote control cable and the rear door inside locking cable and remove the rear door trim board sub-assembly.



7. REMOVE REAR DOOR TRIM NO. 2 BRACKET


    B190583
  1. Remove the 2 screws and remove the rear door trim No. 2 bracket.



8. REMOVE REAR DOOR SERVICE HOLE COVER


    B190584
  1. Disengage the clamps and disconnect the connectors.



    B195023
  1. Remove the rear door service hole cover.

    NOTICE:
    Remove any tape remaining on the door.



9. REMOVE REAR DOOR GLASS RUN


    B190552
  1. Remove the front door glass run.



10. REMOVE REAR DOOR WINDOW FRAME REAR LOWER SUB-ASSEMBLY


    B190586E01
  1. Loosen nut A.

  1. Remove the 3 bolts and remove the rear door window frame rear lower sub-assembly.

    NOTICE:
    Do not drop or damage the rear door window frame rear lower sub-assembly.



11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY


B190588
  1. Provisionally install the power window switch.

  1. Move the rear door glass until the 2 bolts can be seen through the service holes.

  1. Remove the 2 bolts and remove the rear door glass sub-assembly.

    NOTICE:
    Do not damage the door glass.



12. REMOVE REAR DOOR LOCK


    B192117
  1. Using a "TORX" socket wrench T30, remove the 3 screws.

  1. Move the rear door lock downward and pull the release plate out of the rear door outside handle frame.

  1. Remove the door lock wire harness seal from the rear door lock.



    B192545E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.



    B192547
  1. Remove the rear door lock remote control cable.



    B192548E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.



    B192550
  1. Remove the rear door inside locking cable.