STEERING WHEEL > INSTALLATION |
| 1. INSTALL STEERING WHEEL PAD ATTACHING SCREW |
![]() |
Install the 2 steering wheel pad attaching screws.
| 2. INSTALL CRUISE CONTROL MAIN SWITCH |
![]() |
Install the cruise control main switch with the 2 screws.
| 3. INSTALL STEERING PAD COVER RH (w/o Steering Pad Switch) |
![]() |
Engage the 2 pins to install the steering pad cover RH with the screw.
| 4. INSTALL STEERING PAD COVER LH (w/o Steering Pad Switch) |
![]() |
Engage the 2 pins to install the steering pad cover RH with the screw.
| 5. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch) |
![]() |
Engage the 4 pins to install the switch with the 2 screws.
Connect the connector.
| 6. ADJUST SPIRAL CABLE |
![]() |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.
| 7. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and steering main shaft.
Install the steering wheel set nut.
| 8. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 9. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 10. INSTALL STEERING PAD |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Check that the horn sounds.
If the horn does not sound, inspect the horn system.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. INSPECT STEERING PAD |
| 13. INSPECT SRS WARNING LIGHT |