Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ANTENNA

NAVIGATION ANTENNA > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here ).



3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. Remove the instrument panel (Click here ).



4. REMOVE NO. 1 HEATER TO REGISTER DUCT
  1. Detach the clamp.



  1. Remove the 5 <G> or <H> screws and duct.


    B192352



5. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


B192354
  1. Remove the 2 <G> or <H> screws.

  1. Detach the 2 claws and remove the duct.



6. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


B192353
  1. Remove the 2 <G> or <H> screws.

  1. Detach the 2 claws and remove the duct.



7. REMOVE DEFROSTER NOZZLE ASSEMBLY


B192355
  1. Remove the 3 <G> or <H> screws and the defroster nozzle.



8. REMOVE NAVIGATION ANTENNA ASSEMBLY


    E159004
  1. Disengage the clamp.

  1. Remove the 2 screws and antenna.