Home › Engine / Hybrid System ยท 3UR-FE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR ASSEMBLY
  1. Remove the radiator assembly (Click here).



2. SEPARATE FRONT STABILIZER BAR


    A163772
  1. Remove the 4 bolts, 2 stabilizer brackets and 2 stabilizer bushes, separate the stabilizer bar.



3. REMOVE CRANKSHAFT PULLEY


    A164228E01
  1. Using SST, loosen the crankshaft pulley set bolt.

    SST
    09213-70011  
    09330-00021  

  1. Partially install the pulley set bolt to the crankshaft until 2 or 3 threads are engaged.



    A164229E01
  1. Using the pulley set bolt and SST, remove the crankshaft pulley.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05010, 09954-05021)



4. REMOVE CRANKSHAFT TIMING GEAR KEY


    A163993
  1. Remove the crankshaft timing gear key from the crankshaft.



5. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    A163774
  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.