AIR CONDITIONING SYSTEM > Rear Air Conditioning Control Panel Circuit |

| 1.INSPECT FUSE (LH-IG) |
![]() |
Remove the LH-IG fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| LH-IG fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - FUSE, BODY GROUND) |
Disconnect the S4 air conditioning control connector.
![]() |
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S4-4 (E) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| S4-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
Reconnect the air conditioning control connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the S4 air conditioning control connector.
Disconnect the H67 air conditioning amplifier connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H67-13 (RLIN) - S4-5 (RLIN) | Always | Below 1 Ω |
| S4-5 (RLIN) - Body ground | Always | 10 kΩ or higher |
Reconnect the air conditioning amplifier connector.
Reconnect the air conditioning control connector.
|
| ||||
| OK | |
| 4.REPLACE AIR CONDITIONING CONTROL |
Replace the air conditioning control with a new or properly functioning one (Click here ).
Operate the rear power seat module to check that it functions properly.
|
| ||||
| OK | ||
| ||