AIR CONDITIONING SYSTEM > Air Conditioning Control Panel does not Operate |

| 1.INSPECT FUSE (ECU-IG NO. 1) |
![]() |
Remove the ECU-IG No. 1 fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG No. 1 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - BATTERY, BODY GROUND) |
![]() |
Disconnect the H45 integration control and panel connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H45-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| H45-1 (GND) - H45-16 (IG+) | Ignition switch ON | 11 to 14 V |
Reconnect the integration control and panel connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - INTEGRATION CONTROL AND PANEL) |
![]() |
Disconnect the H45 integration control and panel connector.
Disconnect the H24 air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H45-3 (STX) - H24-37 (LIN1) | Always | Below 1 Ω |
| H45-3 (STX) - Body ground | Always | 10 kΩ or higher |
Reconnect the air conditioning amplifier connector.
Reconnect the integration control and panel connector.
|
| ||||
| OK | |
| 4.REPLACE INTEGRATION CONTROL AND PANEL |
Replace the integration control and panel with a new or properly functioning one (Click here).
Operate the air conditioning control to check that it functions properly.
|
| ||||
| OK | ||
| ||