DTC U0230 Lost Communication with Rear Gate Module |
| DTC Code | DTC Detection Condition | Trouble Area |
| U0230 | There is no communication from the power back door unit assembly (power back door ECU). |
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and CAN branch wire.
| NEXT | |
| 3.CHECK FOR OPEN IN CAN BUS WIRE (POWER BACK DOOR ECU CAN BRANCH WIRE) |
![]() |
Disconnect the O30 power back door unit assembly (power back door ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O30-6 (CANP) - O30-5 (CANN) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Power Back Door Unit Assembly [Power Back Door ECU]) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (POWER BACK DOOR ECU - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O30-12 (B) - Body ground | Always | 11 to 14 V |
| O30-10 (ECUB) - Body ground | Always | 11 to 14 V |
| O30-8 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O30-11 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Power Back Door Unit Assembly [Power Back Door ECU]) |
|
| ||||
| OK | ||
| ||