POWER WINDOW CONTROL SYSTEM > INITIALIZATION |
| INITIALIZE POWER WINDOW CONTROL SYSTEM (POWER WINDOW REGULATOR MOTOR (for DRIVER AND PASSENGER SIDE DOORS)) |
Initialization procedures when replacing the power window regulator motor with new one.
Connect the battery and turn the ignition switch to ON. At this time, the LED on the power window switch blinks to indicate that it is ready for initialization.
Fully open the window by fully pushing the power window switch, and hold the switch for 1 second or more after the window is fully opened.
Fully close the power window by fully pulling the power window switch, and hold the switch for 1 second or more after the window is fully closed to reset the glass position. The LED on the power window switch changes from blinking to illuminated to indicate that the initialization is complete.
Initialization procedures when removing/installing the power window regulator motor or power window does not fully open.
Connect the battery and turn the ignition switch to ON.
Fully close the power window by fully pulling the power window switch, and hold the switch up for 6 seconds or more after the window is fully closed. If the power window does not move or stops halfway even when the switch is fully pulled, release the switch and fully pull it again.
Fully open the window by pushing down the power window switch, and hold the switch down for 1 second or more after the window is fully opened.
Release the power window switch. Then fully push and hold the switch 4 seconds or more.
Fully close the power window by fully pulling the power window switch, and hold the switch 1 second or more after the window is fully closed to reset the glass position. The initialization is complete.
| INITIALIZE BACK DOOR POWER WINDOW CONTROL SYSTEM (BACK DOOR POWER WINDOW REGULATOR MOTOR) |
Push the DOWN switch (MANUAL DOWN or AUTO DOWN) to lower the back door power window until it is about one-quarter open.
Fully close the back door power window by pulling up the switch (UP) and then hold the switch up for an additional 1 second or more to reset the power window motor and complete the initialization.
If the back door power window opens after the held switch is released, then the reset failed. Repeat the reset procedure again.