Home › Vehicle Interior › SEAT › REAR POWER SEAT CONTROL SYSTEM

REAR POWER SEAT CONTROL SYSTEM > Rear Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The fold seat control ECU receives signals from the rear door courtesy switch and detects the state of the rear door (open/close). If the ECU does not detect that the rear door is open, the seat folding and return functions are not available.

WIRING DIAGRAM


B195054E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (REAR DOOR COURTESY SWITCH)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream ON.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. According to the display on the Techstream, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    RL Door Courtesy SW
    Rear door courtesy light switch LH signal / ON or OFF
    ON: Rear door courtesy light switch LH ON
    OFF: Rear door courtesy light switch LH OFF
    -
    RR Door Courtesy SW
    Rear door courtesy light switch RH signal / ON or OFF
    ON: Rear door courtesy light switch RH ON
    OFF: Rear door courtesy light switch RH OFF
    -

    OK:
    When rear door courtesy light switch operation is performed, the results are the same as above.



NG
GO TO REAR DOOR COURTESY SWITCH CIRCUIT (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH - FOLD SEAT CONTROL ECU)
B194853E02
  1. Disconnect the O7 or P7 switch connector.

  1. Disconnect the O34 or P20 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    LH Side 
    Tester Connection
    Condition
    Specified Condition
    O7-1 - O34-4 (R CL)
    Always
    Below 1 Ω
    O7-1 - Body ground
    Always
    10 kΩ or higher

    Standard Resistance:
    RH Side 
    Tester Connection
    Condition
    Specified Condition
    P7-1 - P20-4 (R CL)
    Always
    Below 1 Ω
    P7-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE