Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU

CLEARANCE WARNING ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE RH


B190151
  1. Detach the 9 claws and remove the scuff plate.



4. REMOVE COWL SIDE TRIM BOARD RH


B190152
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board.



5. REMOVE INSTRUMENT SIDE PANEL RH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B226758
  1. Detach the clip and 4 claws.

  1. Detach the 2 guides and remove the under cover.



7. REMOVE LOWER INSTRUMENT PANEL


    B226759
  1. Remove the screw <D> and bolt <A>.

  1. Detach the 2 claws and remove the panel.



8. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B226007
  1. Remove the 3 bolts and remove the instrument panel airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B226741
  1. Remove the bolt <A> and 3 <D> screws.

  1. Detach the 3 claws and remove the finish panel.



    B230430
  1. Disconnect the connector.



10. REMOVE NO. 1 ECU INTEGRATION BRACKET


    E191462
  1. Disconnect the ECU connectors and detach the harness clamp.

    NOTICE:
    Do not apply excessive force to the wire harnesses.

  1. Remove the bolt, nut and No. 1 ECU integration bracket.



11. REMOVE CLEARANCE WARNING ECU ASSEMBLY


    E161797
  1. Remove the 2 nuts and clearance warning ECU from the bracket.

    NOTICE:
    1. Avoid any impact to the clearance warning ECU.
    2. Do not drop the ECU. If it is dropped, replace it with a new one.