Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE RH


B190151
  1. Detach the 9 claws and remove the scuff plate.



4. REMOVE COWL SIDE TRIM BOARD RH


B190152
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board.



5. REMOVE INSTRUMENT SIDE PANEL RH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B226758
  1. Detach the clip and 4 claws.

  1. Detach the 2 guides and remove the under cover.



7. REMOVE LOWER INSTRUMENT PANEL


    B226759
  1. Remove the screw <D> and bolt <A>.

  1. Detach the 2 claws and remove the panel.



8. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B226007
  1. Remove the 3 bolts and remove the instrument panel airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.