Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

DTC    C1789    Vehicle Identification Malfunction

for Preparation Click here


DESCRIPTION

  1. This DTC is stored when the suspension control ECU is initialized and is cleared when the vehicle identification information received through the CAN communication system is correctly stored in the EEPROM.
  2. DTC C1789 is stored when an incorrect ECM is installed, as the vehicle specification and data do not match.

DTC Code
Detection Condition
Trouble Area
C1789
Either condition is met:
  1. The vehicle identification information is not stored.
  2. The information stored in the suspension control ECU and the vehicle identification information received through the CAN communication system do not match.
  1. Suspension control ECU
  2. ECM

INSPECTION PROCEDURE

NOTICE:
  1. After replacing the suspension control ECU, perform registration (Click here).
  2. Do not exchange the suspension control ECU with a normally functioning one from another vehicle to perform troubleshooting.

1.PERFORM REGISTRATION
  1. Perform registration (Click here).


NEXT


2.CHECK FOR DTC
  1. Clear DTC (Click here).

  1. Check if DTC C1789 is output (Click here).

    OK:
    DTC C1789 is not output.



NG
Go to step 3
OK

END 

3.CHECK PART NUMBER
  1. Check that the part number of the installed ECM is correct (Click herefor 3UR-FE, Click here for 3UR-FBE).

    NOTICE:
    When removing the ECM to check the part number, or when replacing the ECM, be sure to follow the appropriate procedures and precautions.

    OK:
    ECM with correct part number is installed.

    Result 
    Result
    Proceed to
    OK
    A
    NG
    for 3UR-FE
    B
    for 3UR-FBE
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A


4.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


5.CHECK FOR DTC
  1. Check if DTC C1789 is output (Click here).

    OK:
    DTC C1789 is not output.

    HINT:
    If no parts are replaced and DTC C1789 is output, there may be an internal malfunction in the suspension control ECU. In this case, replace the suspension control ECU.



NG
REPLACE SUSPENSION CONTROL ECU (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)