Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

DTC    CB-13    USB Over Current Detection

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
CB-13
"iPod" or USB device overcurrent malfunction
  1. "iPod" or USB device
  2. Harness or connector
  3. No. 1 stereo jack adapter assembly
  4. Multi-media interface ECU

WIRING DIAGRAM


E183263E89


INSPECTION PROCEDURE

1.REPLACE USB Device OR "iPod"
  1. Disconnect the USB device or "iPod" from the stereo jack adapter.

  1. Turn the ignition switch off.

    HINT:
    When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the stereo jack adapter.


NEXT


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    Malfunction disappears.



NG
Go to step 4
OK

USB DEVICE OR "iPod" WAS DEFECTIVE 

4.CHECK MULTI-MEDIA INTERFACE ECU


    E193009E01
  1. Disconnect the H107 No. 1 stereo jack adapter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H107-1 (UPI) - H107-4 (UJSG)
    Always
    5 V



NG
Go to step 5
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)  

5.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - STEREO JACK ADAPTER)


    E192999E01
  1. Disconnect the H114 multi-media interface ECU connector.

  1. Disconnect the H107 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H114-4 (UDO) - H107-4 (UJSG)
    Always
    Below 1 Ω
    H114-1 (UESG) - H107-1 (UPI)
    Always
    Below 1 Ω
    H114-4 (UDO) - Body ground
    Always
    10 kΩ or higher
    H114-1 (UESG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)