Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for DVD)

DTC    B15BB    Multi-media Interface ECU Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when a malfunction occurs in the multi-media interface ECU.

DTC No.
DTC Detection Condition
Trouble Area
B15BB
When one of the conditions below is met:
  1. System microprocessor malfunction
  2. Media interface microprocessor malfunction
  3. CD-LSI (Large Scale Integration) malfunction
  4. Internal power supply malfunction
  1. "iPod" or USB device
  2. Harness or connector between multi-media interface ECU and No. 1 stereo jack adapter assembly
  3. No. 1 stereo jack adapter assembly
  4. Multi-media interface ECU

WIRING DIAGRAM


E193011E47


INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTC.

1.REPLACE "iPod" OR USB DEVICE
  1. Disconnect the USB device or "iPod" from the stereo jack adapter.

  1. Turn the ignition switch off.

    HINT:
    When one of these DTCs has been stored, is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the stereo jack adapter.

    HINT:
    If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.


NEXT


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.RECHECK DTC
  1. Recheck DTCs and check if the same DTC occurs again.

    OK:
    Malfunction disappears.



NG
Go to step 4
OK

USB DEVICE OR "iPod" WAS DEFECTIVE 

4.INSPECT MULTI-MEDIA INTERFACE ECU


    E193009E05
  1. Disconnect the H107 No. 1 stereo jack adapter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H107-1 (UP1) - H107-4 (UJSG)
    Always
    5 V



NG
Go to step 5
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)  

5.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - STEREO JACK ADAPTER)


    E192999E10
  1. Disconnect the H114 multi-media interface ECU connector.

  1. Disconnect the H107 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H114-1 (UESG) - H107-1 (UP1)
    Always
    Below 1 Ω
    H114-4 (UDO) - H107-4 (UJSG)
    Always
    Below 1 Ω
    H114-1 (UESG) - Body ground
    Always
    10 kΩ or higher
    H114-4 (UDO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)