Home › Engine / Hybrid System ยท 1UR-FE › EMISSION CONTROL › EGR COOLER

EGR COOLER > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY


    A214297E01
  1. Install a new gasket and the No. 2 EGR pipe with the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Make sure the gasket's claws are not caught between the No. 2 EGR pipe and EGR cooler.



2. INSTALL EGR COOLER ASSEMBLY


    A214295
  1. Install the EGR cooler with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



3. INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY
  1. Install 2 new gaskets.



    A214293E01
  1. Install the EGR pipe with the 4 nuts, and tighten the nuts in the sequence shown in the illustration.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



4. CONNECT NO. 11 WATER BY-PASS HOSE


    A214832E01
  1. Connect the No. 11 water by-pass hose.

    HINT:
    The direction of the hose clamp is indicated in the illustration.



5. CONNECT NO. 8 WATER BY-PASS HOSE


    A214291E01
  1. Connect the No. 8 water by-pass hose.

    HINT:
    The direction of the hose clamp is indicated in the illustration.



6. INSTALL NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY


    A214289E01
  1. Install the No. 3 water by-pass pipe with the 2 bolts and connect the hose.

    HINT:
    The direction of the hose clamp is indicated in the illustration.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the No. 4 water by-pass hose.



7. INSTALL INTAKE MANIFOLD ASSEMBLY
  1. Install the intake manifold (Click here).